Structural principle of hydraulic pump station
Cylinder block and piston rod raw materials of hydraulic pump station:
The hydraulic pump station is made of high-density alloy steel according to the Z low safety factor specification. The surface of the piston rod and piston ring is provided with lubricating wear-resistant coating, which has excellent wear-resistant performance.
The steel stop ring further improves the anti side pressure ability of the hydraulic pump station and prevents the piston from extending excessively.
Raw materials for oil seal and reset tension spring of hydraulic pump station:
The high pressure resistant oil seal used in the aviation industry ensures the high quality performance and reliability of the cylinder produced. Most types are equipped with movable bases for maintenance. The coating of the piston rod itself can prevent corrosion and extend the service life.
The strong reset tension spring helps the piston with unidirectional effect to completely reset, and the annular area of the built-in or external hydraulic pump station with unidirectional effect can resist the overload caused by incorrect operation.
Interface raw materials of hydraulic pump station:
Each hydraulic pump station is equipped with a high flow quick connector to ensure free flow of liquid.
The bottom of the cylinder body of the hydraulic pump station is equipped with threaded assembly holes, and the hydraulic pump station with an installed capacity of more than 50 tons is equipped with lifting rings or handles, which is helpful for on-site installation.